
Services
Fuming, ebonizing, bleaching, wire brushing, dyes and ceruse: the specialty finishing techniques we use on fine wood floors in Carnegie Hill townhouses and apartments.
Carnegie Hill townhouses and prewar apartments often call for a floor color that a stock stain cannot give. Our hardwood floor staining and custom color service develops color on your own floor, matches existing colors after repairs, and offers specialty techniques from fuming to ceruse.
Every project is led by Joe Avila, an NWFA certified installer, sander and inspector. It starts with water popping, which opens the grain so stain takes evenly, extra sanding with Lagler Trio sanders, and unlimited samples so you approve the color on your own floor.

Bleaching and Lye Pre-Treatments
Bleaching creates a mild white-washed look. It can also tone down reddish or pink colors that show through lighter stains.
Lye pre-treatments are applied before staining or finishing to give some woods a white or gray driftwood color. That base can be finished naturally or coated with another color, as in our custom color effects range.

Fuming and Ebonizing
Fuming is a graying effect caused by a natural reaction with the tannins in certain woods. Ebonizing is a graying or blackening effect from the same kind of natural reaction.
Because both rely on the wood’s own tannins, they suit only certain species. Where they do not fit, grey tones can also be built with lye and color oil, like the sample shown here.

Pre-Coloring and Dyes
Pre-coloring uses dyes before finishing to create very deep color or textured looks. It is applied as a separate step, before the finish goes on.
Dyes are also the answer for woods that are hard to stain evenly, and for looks a stain cannot reach, such as black floors. Browse our stain colors to see the range.

Color is the most personal decision in a wood floor, and the hardest to get right on site.
Wire Brushing and Ceruse
Wire brushing is a texturing technique that removes some of the soft grain of the wood, leaving a textured surface.
Ceruse is an old woodworking technique that makes the grain a different color from the rest of the wood, for a two-toned look. Our cerused oak post shows where it fits.

Low-VOC Color and Matching After Repairs
Traditional stains give off strong fumes, and with them you should plan to be out of the home for 48 to 72 hours. Our low and zero-VOC options make it possible to stay. Water-based finishes dry in 4 to 6 hours, while oil-based finishes need 12 to 24 hours before light foot traffic.
When boards are replaced after water damage or wear, the whole room is sanded and refinished so new and old boards share one color and sheen; see our repair and water damage service. To start your color samples, book a virtual consultation or email joe@hugginsflooring.com.
Quick Answers
What is water popping?
A water pretreatment that opens the wood grain so the stain takes more evenly.
What is the difference between fuming and ebonizing?
Both are natural reactions with the tannins in certain woods. Fuming gives a graying effect; ebonizing gives a graying or blackening effect.
Can I stay home while my floors are stained?
With our low and zero-VOC options, yes. Traditional stains usually mean being out of the home for 48 to 72 hours.
About The Author
Joe Avila is the founder of Huggins Wood Floor Specialist and leads New York City Wood Floors, a Huggins Wood Floor Specialist brand. He brings 26 years in wood flooring, is NWFA certified (CSI, CI, CWFI, CFS), and teaches AIA, IDCEC and ASID continuing-education courses. See his certifications. Call 908-232-6600 or email joe@hugginsflooring.com.
Related Reading
Contact New York City Wood Floors
Email: joe@hugginsflooring.com
Phone Number: 908-232-6600
Address: 406B West Broad Street, Westfield, NJ, 07090
Leave a Reply